PC406-D - Yamaha

General
Output Power, 1kHz, Non-clip, 20msec Burst, All channels driven:
- 16 O: 300W x 4
- 8 O: 600W x 4
- 4 O: 900W x 4
- 2 O: 1300W x 4
- 8 O (Bridge mode): 1800W x 2
- 4 O (Bridge mode): 2600W x 2
Amplifier class: Class D, Single ended output
Total harmonic distortion: 0.01% (8O, 1kHz, 10W, All channels driven), 0.1% (4O, 1kHz, Half power, All channels driven)
Frequency response: +0.5, -1.5dB @8O, 1W, 20Hz to 20kHz (HPF Thru)
Crosstalk: <= -60dB (8O, 1kHz, Half power, Input 150O shunt A-weighted)
S/N ratio: 109dB (8O, Gain setting = 32dB, A-weighted)
Voltage Gain/Sensitivity:
- 8 O Volume max: 32.0dB/+7.0dBu (Gain setting: 32dB), 26.0dB/+13.0dBu (Gain setting: 26dB), 35.0dB/+4.0dBu (Gain setting: +4dBu), 25.0dB/+14.0dBu (Gain setting: +14.0dBu)
Cooling: 7 step variable speed fan x 3, front to rear airflow
Maximum input voltage: +25dBu
Input impedance: 20kO (balanced)
Sampling frequency rate: 96kHz
A/D D/A Converters: AD: 24-bit linear, DA: 24-bit linear
Dante Interface:
- Channel count: 16 IN with Dante Redundancy, 16 OUT
- Sampling frequency: 96/88.2/48/44.1kHz
- Dante latency: 0.25/0.5/1/2/5ms
- Bit depth: 32/24bit
Processors: 20 x 8 input matrix mixer, Room EQ: 16 band IIR EQ, Room Delay: 0 - 1000msec, Speaker Processor: X-Over (IIR/FIR*), PEQ (16 band IIR/FIR*), Delay, Peak Limiter, RMS Limiter
Latency:
Analog Input to Speakers: 1.5msec, Dante Input to Speakers (Dante latency setup = 0.25msec): 1.8msec (fs=96kHz), 1.9msec (fs=88.2kHz), 2.5msec (fs=48kHz), 2.7msec (fs=44.1kHz)
Power requirements: 100V - 240V 50Hz/60Hz
Power consumption: 1050W (1/8 MAX power, 2O, Pink noise at all channels), 165W (Idle), 100W (Sleep, all channels), 9W (Standby 100V/120V), 12W (Standby 230V)
Operating temperature: 0°C to +40°C
Storage temperature: -20°C to +60°C

Dimensions and Weight
Dimensions:
W: 480mm (18.90 inch)
H: 88mm (3.46 inch): 2U
D: 528mm (20.79 inch)
Net weight: 15.6 kg (34.4 lbs)